I need computer hep

cjm · 09-03-2002, 04:02 PM

I've finished an engine swap using a 90 model 5.0 with the auto computer and harness into my jeep. the engine startes and runs, but the check engine light stays on, the computer will not perform the KOEO test, just get a solid light. Also I can't get any sig. voltage to the tps. I've tried two computers. both were used so its possible they were both bad. I've checked my wireing and grounds. Any help you guys could give me would be great. I don't have a computer at home, so forgive me if I don't respond right back to your messages.
thanks.
jeff

PKRWUD · 09-03-2002, 04:32 PM

I would need to see the schematic you followed to install it.

Take care,
~Chris

bigblockcoupe · 09-03-2002, 05:30 PM

how much of the factory harness did you actually use? just the main computer and injector harness or did you use any of the under dash wiring and fuse panel as well as the alternator and headlight harness or did you integrate it into the jeeps wiring.

09-03-2002, 04:02 PM	#1
cjm Registered Member Join Date: Dec 2000 Location: tuscumbia, Al. Posts: 17	I need computer hep I've finished an engine swap using a 90 model 5.0 with the auto computer and harness into my jeep. the engine startes and runs, but the check engine light stays on, the computer will not perform the KOEO test, just get a solid light. Also I can't get any sig. voltage to the tps. I've tried two computers. both were used so its possible they were both bad. I've checked my wireing and grounds. Any help you guys could give me would be great. I don't have a computer at home, so forgive me if I don't respond right back to your messages. thanks. jeff

09-03-2002, 04:32 PM	#2
PKRWUD Junior Member Join Date: Mar 1999 Location: Ventura, California Posts: 8,981	I would need to see the schematic you followed to install it. Take care, ~Chris __________________ Webmaster: Rice Haters Club Jim Porter Racing Peckerwoods Pit Stop Support Your Local RED & WHITE!

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Which wiring harness and computer do I have to have?	EazyE-CPT	Windsor Power	0	07-21-2002 11:33 PM
Help with C&L 76MM & A9L computer install	venumus93	Windsor Power	19	05-16-2002 07:58 PM
Computer Issues, Check Engine	98SteedaGT	Modular Madness	1	04-27-2002 05:39 PM
A9L Computer	nextime	Windsor Power	14	03-27-2002 10:36 PM
AAAARGH! Steeda timing adjuster causing computer problems!!!	bark3rd	Modular Madness	1	06-04-2001 08:15 PM

09-03-2002, 05:30 PM	#3
bigblockcoupe Registered Member Join Date: Aug 2002 Location: broken arrow Posts: 212	how much of the factory harness did you actually use? just the main computer and injector harness or did you use any of the under dash wiring and fuse panel as well as the alternator and headlight harness or did you integrate it into the jeeps wiring.