Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-08-2003, 10:23 AM
|
#1 |
|
Registered Member
Join Date: May 1999
Location: sloatsburg
Posts: 261
|
could use some technical help
okay im trading my whole tremec 3550 set up for a c4 with a 3800 stall how do i know if this stall is good for my combo. here is my combo i have 373s in the rear on a 26x10 slick with a 306 edelbrock heads rpm air gap intake demon 650 carb 1.7rr the cam is a custom grind the duration is 218/230 the lift is .3010/.3010 and the lobe seperation is 110.0 and i also have a 150-200 shot on there that i havnt used yet. will this stall converter and tranny work for my setup. thanks for any help
__________________
306 edelbrock 6037 heads full mac exuast 1.7 rr 373 rear hd clutch tremec mighty demon 650 carb msd ignition rpm air gap intake custom cam still trying to get it to run right |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 1966 Mustang Technical Help | Cool_Man_128 | Classic Mustangs | 7 | 03-02-2003 05:23 AM |
| Need Technical Help | RX-7Aggie | Windsor Power | 5 | 10-03-2002 12:00 AM |
| Where can I find technical articles? | LT1 Z28 | Blue Oval Lounge | 1 | 03-11-2002 07:35 PM |
| Technical question for EFI people. | Dark_5.0 | Windsor Power | 3 | 10-07-2001 11:01 PM |
| Pro Stock Technical Questions | Street Heat Racing | Racer's Club House | 1 | 07-01-1999 09:31 PM |