Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-13-2003, 11:30 AM
|
#1 |
|
Registered Member
Join Date: Jul 2000
Location: Norman, Oklahoma, USA
Posts: 597
|
Cutting valve reliefs into early pistons
Does anyone know how deep valve reliefs can be cut into late 70's flat top 302 pistons? Just how thick do you think the tops of the pistons are? Thanks.
__________________
Michael Black QuantumMotorsports Norman, OK 1984 LX Hatch 306 w/ TRW forged flat toppers, Comp Cams Magnum 292H, GT40P heads w/ 3 angle valve job, .550 lift springs, Angus Racing Roller Rockers, Weiand Stealth Intake, Holley 4150 650cfm carb, MAC 1 5/8 Long Tubes, Single Chamber Flowmasters, 91' T5 w/ Pro 5.0 shifter, Turbo Coupe 8.8 Rear w/ 3.55 gears, QA1 Motorsports tubular K member, no interior except steering wheel and seat. Coming soon: 6 or 8 point cage, Fuel Cell, Weld Draglites |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| valve problem | pearlgt40 306 | Windsor Power | 3 | 07-05-2003 01:21 AM |
| Largest cam in 351W without cutting the pistons (Looking at AFR185s) | Fox Body | Windsor Power | 10 | 06-15-2003 12:39 AM |
| Pistons for Larger Valves? | MustangChile | Classic Mustangs | 4 | 02-28-2003 01:27 AM |
| PCV Valve what the ?@#$@#$@$ | Chevyguy | Windsor Power | 3 | 04-11-2001 08:01 PM |
| fly cutting pistons? | gpinto2 | Windsor Power | 1 | 01-02-2001 12:11 AM |