04-23-2003, 11:23 AM
| #1 (permalink) |
| Registered Member  Join Date: Sep 2002 Location: southeast texas
Posts: 90
|  Cylinder misfire Motor running fine back in Nov.2002 primmed oil before firing Bad miss #2 plug fuel fouled Header tube does'nt get over 130 deg F(others run 680 at idle) Pulled upper(track heat) and watched injectors through lower spray,no prob; intake valve appers to open and close fully. Pulled plug and comfirmed fire at plug...even swapped out plug. Wire for #2 ohms out at 2013 ohms(1000 ohms per foot general rule) . Any Ideas?
__________________ AFR 1492 heads,Track Heat Intake, d.s.s super pro bullet 331, lakewood bell, king cobra, 3550 ,UPR shifter, aluminum shaft, 4.10, 31-spline, spool,hoosier27x10, moroso ds-2, 175-juice, egt...11.40 on motor spray pass coming. |
|      |
|
04-24-2003, 07:40 AM
| #2 (permalink) |
| Registered Member Join Date: Sep 2002 Location: southeast texas
Posts: 90
| Oh yeah I almost forgot.....compression checks out good.
__________________ AFR 1492 heads,Track Heat Intake, d.s.s super pro bullet 331, lakewood bell, king cobra, 3550 ,UPR shifter, aluminum shaft, 4.10, 31-spline, spool,hoosier27x10, moroso ds-2, 175-juice, egt...11.40 on motor spray pass coming. |
|
| |
| Sponsored Links | |
| | |
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rocker adjustment | zach0 | Classic Mustangs | 3 | 04-24-2004 01:28 PM |
| 8 cylinder into a 6 cylinder engine bay....? | EclipseGST303 | Windsor Power | 8 | 10-04-2002 02:57 PM |
| 8 cylinder into a 6 cylinder engine bay....? | EclipseGST303 | Modular Madness | 1 | 10-02-2002 08:31 PM |
| master cylinder and prop valve question | shelby2 | Classic Mustangs | 1 | 07-05-2002 06:32 PM |
| master cylinder? | Fostang | Classic Mustangs | 0 | 06-10-2002 02:04 AM |
Linear Mode
