MustangWorks.com : Ford Forums - View Single Post - Do I have to remove rack to install bushings?

LOCASH · 01-28-2001, 07:38 PM

I lowered the car a while ago but I didn't have time to put the offset bushings in. I just read an article that said I can just disconnect the 2 bolts and pull the rack forward to, uh, "facilitate entry".(heh, heh, he said..). Is this true? Can I do it without disconnecting the tie rods or the power steering lines?

------------------
86 GT T-tops, AOD, B&M shift kit and hammer shifter, ROH wheels, K&N, Timing,MAC headers, 2.5 off road H, 2.5 American Thunder, 87 spindles, rear disc,SS lines, BBK 1.5, poly bushings, Steeda G-trac and subs, Strut bar.
"DRIVE LIKE YOU STOLE IT!"

01-28-2001, 07:38 PM	#1
LOCASH Registered Member Join Date: Oct 2000 Location: Santa Lucia di Budoia, Italy Posts: 217	Do I have to remove rack to install bushings? I lowered the car a while ago but I didn't have time to put the offset bushings in. I just read an article that said I can just disconnect the 2 bolts and pull the rack forward to, uh, "facilitate entry".(heh, heh, he said..). Is this true? Can I do it without disconnecting the tie rods or the power steering lines? ------------------ 86 GT T-tops, AOD, B&M shift kit and hammer shifter, ROH wheels, K&N, Timing,MAC headers, 2.5 off road H, 2.5 American Thunder, 87 spindles, rear disc,SS lines, BBK 1.5, poly bushings, Steeda G-trac and subs, Strut bar. "DRIVE LIKE YOU STOLE IT!"