Draining a Radiator on a 94 GT
 

Does anyone know where the bolt is to remove so that you can drain a stock radiator on a 94 GT? I think it's on the passenger side of the radiator but I can't see it...

------------------
TFS twisted wedge heads, TFS street intake, Lunati cam .500/.510 218/226, BBK FPR
BBK shorties, BBK 70mm tb, Pro-m 75mm, ASP pulleys, FMS 3:73, Transgo shiftkit
Flowmasters, Bassani x-pipe, K&N FIPK, FMS 1.6 roller rockers, 9mm wires,24lbs injectors,
190lph fuel pump, MSD cap and rotor, 18" wheels w/street tires

its on the passenger side at the very bottom its a white plug that you screw off.

Mine was not a white plug, but a plastic black one. Maybe the white paint wore off, but it's right down there next to the ABS stuff. When I drained my radiator, I just took off the lower radiator hose.

------------------
Blueneonman - '95 5.0L Mustang GT Convertible | K&N Custom Cold Air Intake | FMS 9mm Wires | Hollow Cats | Flowmaster 2 Chambers | BBK Subframes | 6-pt Rollcage | King Cobra Clutch | FMS Adjustable Clutch Cable | B&M Short Throw | Coolest Neon Lighting on a Mustang EVER!

Homepage: http://www16.brinkster.com/blueneonman/

also there is a plug/screw in each side of the engine...to drain the block...

Yes, slo95 is right. If you are going to drain your cooling system completely, there are 2 plugs located right above the freekin motormounts! What a *****! Good luck.

------------------
Blueneonman - '95 5.0L Mustang GT Convertible | K&N Custom Cold Air Intake | FMS 9mm Wires | Hollow Cats | Flowmaster 2 Chambers | BBK Subframes | 6-pt Rollcage | King Cobra Clutch | FMS Adjustable Clutch Cable | B&M Short Throw | Coolest Neon Lighting on a Mustang EVER!

Homepage: http://www16.brinkster.com/blueneonman/