07-02-2002, 09:06 AM
| #1 (permalink) |
| Registered Member Join Date: Mar 2002 Location: DC
Posts: 129
|  Which Driveshaft to use???? I'm doing a 4cyl to V8 swap in my 89 stang. Could I use a driveshaft from a lincoln Mark VII w/aod? I'm currently installing a 302 w/aod and I can find a mustang driveshaft but I've found tons of Mark VII driveshafts. Are they both the same? |
|      |
|
07-02-2002, 01:43 PM
| #2 (permalink) |
| Registered Member  Join Date: Jun 2002 Location: manassas, va
Posts: 186
| i would recommend just spending the money on an aluminium driveshaft from summit, 159 dollars. by pass ll the bull crap and get something that will save you money in the long run, cause you will eventually probably buy it later on.
__________________ 1983 mustang, 393 cubic inch stroker small block, victor jr heads and intake, gold race 1.6 roller rockers. comp cam 304, 244@ .050. .576" hydralic retro roller cam,lunati rods. block was o-ringed,10:1 forged pistons, speed pro fit fit rings, clevite bearings,msd distributor and igniton,be cool huge radiator, black lite electric fan, march underdrive pulleys, mildon deep sump oil pan, mac 1 3.4" long tube headers, 3" dr gas x-pipe and mac exhaust,ARP bolts. car weighs 2900 lbs w/out driver, sub frames, weld wheels, mickey thompson sportsman pro 26 x 10.5 x 15's,#8 fuel line steel braided |
|
| |
| Sponsored Links | |
| | |
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Driveshaft or Rear-end | UglyFast88 | Windsor Power | 3 | 06-04-2003 07:16 PM |
| Cam or Driveshaft???? | bigred90gt | Windsor Power | 2 | 11-21-2002 01:05 AM |
| Aluminum Driveshaft getting scraped on acceleration... 1994 GT Parking brake Recall?? | NYC1 | Windsor Power | 5 | 11-17-2002 12:15 PM |
| Tremec in '95-Longer Driveshaft | 95Convert | Windsor Power | 1 | 07-22-2001 05:22 PM |
| Aluminum Driveshaft...Balance? | chris91LX | Windsor Power | 4 | 02-10-2001 11:43 AM |
Linear Mode
