Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-02-2001, 05:02 PM
|
#1 |
|
Registered Member
Join Date: Jul 2000
Location: San Jose CA
Posts: 149
|
E7 cylinder heads
Has anyone taken a before and after bech flow test to find out what exactly cfm is to be gained from removing the thermactor air bump from the exahust port of these heads. Not a full on port and polish job, I realize that is going to increase cfm. But moreover, I would like to see the numbers before and after this bump is removed so I can isolate which operations provide proven enhancement and which ones are a lot of hype and opinion.
thanks |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| New Heads. Any Tips | 66StangGuy | Classic Mustangs | 5 | 09-15-2003 08:20 PM |
| Edel. non-smog to AFR smog legal heads? What do you guys think? | Simi Stang | Windsor Power | 10 | 06-19-2003 11:14 PM |
| Cylinder heads for blown 331 | Dave_mustang_50 | Windsor Power | 7 | 06-18-2003 03:45 PM |
| Best Cylinder Heads? | canary94 | Windsor Power | 7 | 03-31-2002 01:35 PM |
| For whoever it was considering using stock ported heads | 2FastLX | Windsor Power | 5 | 10-11-2001 01:53 PM |