edelbrock performer rpm heads

hippi97 · 04-01-2001, 06:39 PM

I need to know what head bolts,gaskets,and pushrods to use. I know that the pushrods will have to be hardened but can I use stock length?

------------------
85 mustang coupe with a 88 block,83 model heads,crane roller rockers,aluminum driveshaft,C-4 trans,3500 stall,3.73 gears,lakewood traction action liftbars with air bag in right rear spring,longtube headers,flowmasters,
weiand stealth intake,600 holley,
best e.t. 1/8 mile 8.26
best mph. 81.35
best 60 foot 1.73 before liftbars on et streets.

86GT · 04-01-2001, 08:34 PM

Well I've got the Performer heads #6032. I'm using ARP 7/16" head bolts and edelbrock's bushing kit for the heads. I'm running hardened stock length pushrods and Crane roller rockers.

hippi97 · 04-01-2001, 08:40 PM

86gt how long have you had the heads? how much diffrence did thay make over stock?

04-01-2001, 06:39 PM	#1
hippi97 Registered Member Join Date: Apr 2001 Location: cohutta georgia Posts: 43	edelbrock performer rpm heads I need to know what head bolts,gaskets,and pushrods to use. I know that the pushrods will have to be hardened but can I use stock length? ------------------ 85 mustang coupe with a 88 block,83 model heads,crane roller rockers,aluminum driveshaft,C-4 trans,3500 stall,3.73 gears,lakewood traction action liftbars with air bag in right rear spring,longtube headers,flowmasters, weiand stealth intake,600 holley, best e.t. 1/8 mile 8.26 best mph. 81.35 best 60 foot 1.73 before liftbars on et streets.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Edelbrock RPM intake install problems	jruppert	Windsor Power	4	03-04-2004 05:05 PM
Ford Performer RPM Heads	Scrapla	Windsor Power	6	02-19-2004 09:53 AM
GT-40X Alumin. Heads/ Edlebrock Performer intake. Good combo?	yelowjaket	Windsor Power	1	01-16-2003 03:16 PM
Edelbrock heads?	Coupe Devil	Windsor Power	7	07-18-2001 03:58 PM
Edelbrock vs Trick Flow Heads????	Blaster	Windsor Power	8	04-25-2001 04:58 PM

04-01-2001, 08:34 PM	#2
86GT Sniffed too much n20 Join Date: Oct 1998 Location: Ont, Canada Posts: 1,018	Well I've got the Performer heads #6032. I'm using ARP 7/16" head bolts and edelbrock's bushing kit for the heads. I'm running hardened stock length pushrods and Crane roller rockers.

04-01-2001, 08:40 PM	#3
hippi97 Registered Member Join Date: Apr 2001 Location: cohutta georgia Posts: 43	86gt how long have you had the heads? how much diffrence did thay make over stock?