Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
11-15-2002, 01:00 PM
|
#1 |
|
Registered Member
Join Date: Jun 2001
Location: Lynwood, CA, U.S.A.
Posts: 82
|
351W heads on 289 stock engine
Does anyone here know if stock 351W heads can go on a 289 stock engine? I know that 351W heads would have bigger head bolts, but as far as compression due to bigger combustion chambers on the 351W. I think 289 heads are open chamber, but I'm not sure if the 351W heads are the same or not, but if they are closed chamber would I face any concerns there, such as needing bigger gasket or anything. Thanks for help!
__________________
65 Mustang Coupe...Comp Cams 262 Xtreme Energy, T-5 conversion, Romac Balancer, 620 Front Springs-4.5 Mid-eye rear springs.......work in progress |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| will 99-2002 cams out of the pi heads fit in the 96-98 stock heads | slow98 | Modular Madness | 6 | 10-25-2002 04:28 PM |
| Supercharged 351W. SCAT Forged everything setup. Engine build. | Fox Body | Windsor Power | 7 | 10-24-2002 11:08 PM |
| Best Heads For Stock Short Block | StreetStang37 | Windsor Power | 2 | 02-26-2001 11:10 AM |
| 351w heads on 289 | MUSTANGROB | Classic Mustangs | 8 | 05-12-1999 08:59 AM |
| Very bad experience with Engine Dynamics of San Jose CA | JAGraff | Small Ponies | 0 | 05-12-1999 02:27 AM |