EGR Valve Question.

Bobby L · 08-22-2002, 02:07 PM

I just removed the EGR valve from my car and I unbolted the electronic unit that the harness plugs into. Is there supposed to be an o-ring there? I would imagine so or else there would be no vacuum there to open the valve. There is not an 0-ring on mine, but it has a groove that one could fit into. Thanks in advance.

Bobby

RPM427 · 08-22-2002, 02:23 PM

It should have one.

08-22-2002, 02:07 PM	#1
Bobby L Registered Member Join Date: Aug 1999 Location: Alb. New Mexico U.S.A Posts: 10	EGR Valve Question. I just removed the EGR valve from my car and I unbolted the electronic unit that the harness plugs into. Is there supposed to be an o-ring there? I would imagine so or else there would be no vacuum there to open the valve. There is not an 0-ring on mine, but it has a groove that one could fit into. Thanks in advance. Bobby

08-22-2002, 02:23 PM	#2
RPM427 Registered Member Join Date: Aug 2001 Location: Huntington NY Posts: 573	It should have one. __________________ -1993 Mustang, 900rwhp 03-04 cobra based 4v swap, full Griggs setup, project underway -1994 Ranger w/ 427cid windsor (daily beater) check it out!

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Air by pass valve question.	Jaegermeister2k	Power Adders	21	05-06-2005 09:40 PM
Valve cover question	Stang951	Windsor Power	1	03-27-2004 11:57 PM
master cylinder and prop valve question	shelby2	Classic Mustangs	1	07-05-2002 05:32 PM
EGR valve question?	84LX89GT	Windsor Power	3	09-07-2001 02:09 AM
valve train question???	vande97	Windsor Power	0	05-04-2001 05:00 PM