© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-22-2002, 02:07 PM | #1 |
Registered Member
Join Date: Aug 1999
Location: Alb. New Mexico U.S.A
Posts: 10
|
EGR Valve Question.
I just removed the EGR valve from my car and I unbolted the electronic unit that the harness plugs into. Is there supposed to be an o-ring there? I would imagine so or else there would be no vacuum there to open the valve. There is not an 0-ring on mine, but it has a groove that one could fit into. Thanks in advance.
Bobby |
08-22-2002, 02:23 PM | #2 |
Registered Member
Join Date: Aug 2001
Location: Huntington NY
Posts: 573
|
It should have one.
__________________
-1993 Mustang, 900rwhp 03-04 cobra based 4v swap, full Griggs setup, project underway -1994 Ranger w/ 427cid windsor (daily beater) check it out! |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Air by pass valve question. | Jaegermeister2k | Power Adders | 21 | 05-06-2005 09:40 PM |
Valve cover question | Stang951 | Windsor Power | 1 | 03-27-2004 11:57 PM |
master cylinder and prop valve question | shelby2 | Classic Mustangs | 1 | 07-05-2002 05:32 PM |
EGR valve question? | 84LX89GT | Windsor Power | 3 | 09-07-2001 02:09 AM |
valve train question??? | vande97 | Windsor Power | 0 | 05-04-2001 05:00 PM |