MustangWorks.com : Ford Forums

MustangWorks.com : Ford Forums (http://forums.mustangworks.com/index.php)
-   Windsor Power (http://forums.mustangworks.com/forumdisplay.php?f=8)
-   -   ET times??? (http://forums.mustangworks.com/showthread.php?t=1665)

DemonGT 03-13-2001 03:12 PM

ET times???
 
i never take my car to the track so i was wondering if some of you guys could estimate what id run with the little mods i have and some ill be geting soon

K&N,long tubes,off road H,mac cat back,pro 5.0 shifter,3.73's,timing

also for those mods what do you think my timing should be at??

------------------
'91 GT,91K,T-5,air silencer removed,racing clutch(previous owner put in so dont know what kind),K&N air filter,Aiwa deck,power acoustic amp,2 12" pianeers,UPDATE: Just got my Mac long tube headers and Cat-back

Future Mods:3.73's,Pro 5.0,Shifter knob,FMS 9mm wires

Skyman 03-13-2001 03:33 PM

low 14's around 97-98mph. I say 14-15 degree timing.

Sky

------------------
-1989 Saleen Mustang #406- TFS Heads, E-303, edelbrock intake,70MM TB, 73mm MAF, off road H, 2 1/4" exhaust, and 4.10's.
332RWHP@5500
351RWTQ@3750
Runs on 87 Octane!

NOS_Notch 03-13-2001 10:33 PM

You can run 13.70's-13.90's w/ that combo @97-100 mph....If you use a sticky tire...13.50-13.60 w/ full slicks.
My best w/ 4.10's and long tubes + some suspension stuff is 13.20's so you should only lose about 2 tenths w/ your 3.73's



------------------
4.10's,long tubes & 75 shot...Goes 12.50's
Check it out at http://www.burnouts.webprovider.com

Killercanary 03-13-2001 11:17 PM

My dad's 91GT has the following:
3.55 gears
Pro 5.0 shifter
ASP underdrive pulleys
MAC cold air induction
offroad bassani X pipe
Borla mufflers w/ turndowns
14* timing
subframe connectors
and Mickey Thompson sportsman Pro tires
He ran a 14.60 at 94mph stock. With these parts he has run 13.73 at 97.97mph, his best 60' was a 1.89. So if you get some good tires, you'll be in the 13's, but it will take some practice. His car weighes 3370 with him.


------------------
95 GT convt' 5 speed, 3.73's,FMS HD clutch, Pro 5.0 shifter, ASP alum. underdrive pulleys, Bassani offroad X pipe, 2 chmbr flowmasters, K&N w/o silencer, edelbrock performer intake, FRPP 65mm T-body, FRPP shorty headers, FRPP aluminum driveshaft.Hooker 4pt chrome car bar, Xenon/Wings West ground effects, custom interior
Best ET: 13.83
Best MPH: 98.55mph with Best 60': 1.91 on Nitto DR's
Homepage: <A HREF="http://www.angelfire.com/pa2/killercanary" TARGET=_blank>http://www.angelfire

poopstang 03-15-2001 10:02 PM

i ran 14.05@99.98 with 2.73's, timming, cam and rockers.
with 3.73's u should be in the high 13's low 14's

Stang_Crazy 03-15-2001 10:49 PM

It's hard to say because everyone has different driving skills. But, if I have to play along, I'd say low 14's. Maybe you can get a really nice run and rip off a high 13.???

------------------
91 GT AOD: 3.73's, Pulleys,PI Converter, 14.71@91.78mph
(before pulleys)

fiveohpatrol 03-16-2001 10:27 AM

take those subs out too along with about 14 degrees of timing, air up your fronts to about 45-less rolling resistance

------------------
88 Notchback 5.0, 3.73's, Explorer intake, pulleys, Crane 1.7's, BBK headers, off-road H-pipe, flowmasters, subframe connectors, 65mm TB, shift kit, March ram air kit, motorsport wires, MSD coil, upper and lower control arms, 155lph fuel pump, cheap 2800 stall, Crane Adj.FPR, best time- 13.99@99.75, not yet tested times after rocker and intake install


All times are GMT -5. The time now is 02:34 PM.