Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-09-2002, 09:38 AM
|
#1 |
|
Registered Member
Join Date: Mar 2000
Location: minneapolis, mn
Posts: 158
|
exaust question, MAC X-PIPE
I recieved my new MAC X-pipe last night and was putting it in along with some new o2 sensors and after getting it in i noticed there is no way that the Emissions pipe fits onto the fitting for the Emissions. I have tried everything and every combination to get it to go on there. I am thinking of cutting it and re routing it so that it lines up. Anyone have any suggestions on this? IF i cut it, i will have to get another piece of replacement pipe. Anyone know what size that sucker is? THis sucks since i am suppose to have my car in a show tomorrow but i cant get it there due to this damn emissions pipe.
__________________
1991 LX coupe,AOD, red, 80k, K&N, MAC cat back, MAC off-road X, Autometer Gauges, BBK Ceramic unequals, fully polished upper intake, fuel rails, and egr, working on installing.....MM full length subs, H&R sport springs, MM Lower control arms, MM caster camber plates, bilstein shocks, struts. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Power Pipe installation question | p51302 | Power Adders | 2 | 06-02-2004 05:13 PM |
| H- Pipe question | 82 GT | Windsor Power | 5 | 06-01-2004 02:23 PM |
| cat pipe question | slo95 | Windsor Power | 3 | 10-10-2001 08:01 PM |
| H pipe question | DemonLp | Windsor Power | 1 | 03-13-2001 12:19 AM |
| X pipe Question | 97ScottieGT | Modular Madness | 1 | 10-17-2000 11:34 PM |