© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-15-2001, 05:37 PM | #1 |
Sober voice of Reason
Join Date: Nov 1998
Location: Kelowna, B.C., Canada
Posts: 1,514
|
Fiberglass bumpers from a newer car.
The other day I was sitting in class and thinking to myself "how can I make my car lighter?" I was wondering if anyone has tried fitting 87 up bumpers to replace the super heavy Iron bumpers on the older cars? I'm talking about the bumpers inside of the outer bumper covers. This should drop about 50 lbs or more from the car and is safer than pulling the bumpers alltogether. Not to mention I could probably get a set for about $20. Any thoughts?
------------------ GT-40 heads (ported, polished, + milled), B303 cam, 1.7rr's, JE pistons, Offy intake, Carter AFB 625cfm carb, Flowtech 1 5/8" shortys, Flowtech X-pipe, MAC Flowpath exhaust, MAC pulleys, 373's, subframes, Eibachs+Tokicos, B+M ripper, FMS Clutch, Zoom Quadrant+cable, 17" CSA Ultra rims, 235/45ZR17 Yokohama AVS S4's, MSD 6A ignition+coil, FMS 9mm wires, Carbed, Naturally Aspirated, and Nasty! |
03-16-2001, 03:17 AM | #2 |
Guest
Posts: n/a
|
that's such a good idea, my is the big ol' piece of iron also
|
03-16-2001, 02:35 PM | #3 |
Sober voice of Reason
Join Date: Nov 1998
Location: Kelowna, B.C., Canada
Posts: 1,514
|
The rear one looks like a direct fit but the parking lights on the front are going to pose a problem.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Fiberglass body parts | drtbiker | Windsor Power | 3 | 04-01-2003 08:27 AM |
Can i lock a fiberglass hatch? | dragstang86 | Windsor Power | 8 | 11-11-2002 08:52 PM |
Fiberglass door question? | Five0 | Windsor Power | 7 | 09-15-2001 07:10 PM |
How much would you pay for used 68 bumpers? | RedLilPony | Classic Mustangs | 0 | 01-28-2001 04:03 PM |
Bumpers for my '78 mustang II | purple horse | Classic Mustangs | 1 | 12-16-1999 07:41 PM |