Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-05-2002, 02:46 PM
|
#1 |
|
Registered Member
Join Date: Aug 2001
Location: Huntington NY
Posts: 573
|
AFR cylinder heads
I am planning on installing a set of AFR 185 (with 2.02 intake valves) cylinder heads for my 91 GT. I also have a Holley systemax intake along with 3:73’s, 255 in tank fuel pump, MSD ignition.
My question is what cam you suggest I run. I was looking into comp cams xtreme line up. I would like to not modify the short block if possible (i.e. notch pistons). What is the highest amount of lift and duration I can run with 1.6 ratio rockers without notching the pistons? I’ve been told I can go as high as .555 by some, and some tell me I need to notch the pistons regardless of lift due to the larger valve size. Your help will be appreciated.
__________________
-1993 Mustang, 900rwhp 03-04 cobra based 4v swap, full Griggs setup, project underway -1994 Ranger w/ 427cid windsor (daily beater) check it out! |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Edel. non-smog to AFR smog legal heads? What do you guys think? | Simi Stang | Windsor Power | 10 | 06-19-2003 11:14 PM |
| Cylinder heads for blown 331 | Dave_mustang_50 | Windsor Power | 7 | 06-18-2003 03:45 PM |
| Best Cylinder Heads? | canary94 | Windsor Power | 7 | 03-31-2002 01:35 PM |
| For whoever it was considering using stock ported heads | 2FastLX | Windsor Power | 5 | 10-11-2001 01:53 PM |
| E7 cylinder heads | 89LXNB | Windsor Power | 2 | 01-02-2001 11:41 PM |