© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
05-13-2003, 08:11 PM | #1 |
Registered Member
Join Date: Aug 2002
Location: Rochester
Posts: 553
|
fuel gauge problem
This season my mustangs fuel gauge always reads MAX full and bever moves past that point when the car is running. I ordered a new fuel level sending unit from ford, but just curious if anyone else has run into this problem?
|
05-13-2003, 09:54 PM | #2 |
Registered Member
Join Date: Feb 2003
Location: NJ
Posts: 81
|
Hey there what has happened is the sender unit in your gas tank has a electronic board and when you fill and when it is empty the thing moves up and down, what has happened is the connect has worn off, if you take the send unit out of the gas tank you will see what im talking about. its not your gauge.
Ernie
__________________
93 GT 351 to 393 stroker, GT40 upper and lower intake, GT40X Turbo Swirl heads, holley 80mm throttle body, 255 fuel pump, 42 lb injector, JE pistons, Comp cam, comp lifters, comp pushrods, comp springs, crane Roller rockers. Trick flow Crank Shaft, comp Timing chain. MSD 7 series ignition, msd hvc2 coil, MSD timing adjust, MSD Pro billet Dis, Hooker long tube, Off road H pipe 1 chanber race flows, 4.10 gears, Vortech cooler and T-Trim with a 25lb boost AND LOTS MORE. |
05-14-2003, 08:57 AM | #3 |
Registered Member
Join Date: Jan 2003
Location: georgia
Posts: 11
|
i jst got done spending 2 weeks messing with my fuel gauge and finnaly fixed it i would try slaving in the new fuel sender when you get it before droping the tank (pain in the ***). when you slave in the new sender remember that the gauge has an anti slosh chip that is in your instrument cluster. so if you have the sender set to read full and you have the key on and you move the sender the other way the gauge will not move! beacuse it thinks the gas sloshed over and its not getting the correct input from the sender. but if you turn the key off and back on it should read empty because it thinks it is a good reading. make sense? if the new sender doesn't fix it email me or post a message and i will tell you what and where you should have voltage readings. like i said i spent a while messing with mine. hope this helps
|
05-15-2003, 06:30 AM | #4 |
Registered Member
Join Date: Sep 2001
Posts: 512
|
Concur - had the same problem in our 88GT stang. Put in a new sender and problem fixed. Very rarely is the guage the guilty party it's either a ground issue, connection issue, or bad sending unit in the tank.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
fuel gauge install | GhettoPop | Windsor Power | 4 | 01-23-2004 01:41 PM |
fuel pump problem | gizmo83 | Windsor Power | 6 | 08-28-2003 10:15 PM |
Fuel Gauge Problem | RedMonsterGT | Windsor Power | 2 | 10-21-2002 07:45 PM |
Fuel Gauge install questions | Chipdog | Windsor Power | 0 | 08-12-2001 07:06 PM |
Fuel Pressure Gauge | 86GT | Windsor Power | 6 | 02-07-2001 11:55 PM |