Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|||||||
|
|
Thread Tools | Rate Thread | Display Modes |
05-25-2001, 07:27 PM
|
#1 |
|
Registered Member
Join Date: May 2001
Posts: 1
|
Question for those that have converted to EFI Fuel Injection.
I have some questions concerning the wiring harness. I have a complete engine harness with all sensors from a 92 mustang. I have all of the fuel injection hardparts from the same vehicle as well. I noticed that the engine harness ties into the chassis harness in a few places; ie. by the brake booster. What is this connection for? Is this where the harness is recieving a ground or power? What do i need to do in order to make this harness work in my 67? I am using the 5.0 motor and am using the factory intank pump setup with the fuel pump relay, etc.
Any insight to this would be greatly appreciated. TIA |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| fuel pressure issues | mustang98gt | Modular Madness | 3 | 07-05-2003 10:43 PM |
| Fuel pressure question - HELP! | Stang_ROTY | Windsor Power | 30 | 05-30-2003 08:20 AM |
| Fuel injection load problem | Mountain Main | Windsor Power | 12 | 03-21-2003 12:22 PM |
| 351 Windsor Fuel injection? | grant66 | Windsor Power | 9 | 07-25-2002 11:42 AM |
| Fuel pump & regulator question | roadrunner93 | Windsor Power | 2 | 02-18-2001 09:01 PM |