Putting exhaust on a 89

GodStang · 03-28-2002, 10:32 PM

I am about to put bbk headers, bassani x-pipe, and flowmasters on a 89 gt. I have never done this model before. Anything to be careful of? Does it fit to stock hangers? Any special tricks for the headers? Any help will be much apprecatied.

sn95gt19 · 03-28-2002, 11:48 PM

you didnt say if they were equal length headers or just reg. i had a prob with the driver side header but if you just force it down past the master cylinder they fit fine it just takes some pushing. i had a bbk x pipe and the hangers that were for the trans crossmember didnt line up, so i didnt even use them it held up fine

03-28-2002, 10:32 PM	#1
GodStang College Stanger Join Date: May 1999 Location: Aiken,south carolina, usa Posts: 1,097	Putting exhaust on a 89 I am about to put bbk headers, bassani x-pipe, and flowmasters on a 89 gt. I have never done this model before. Anything to be careful of? Does it fit to stock hangers? Any special tricks for the headers? Any help will be much apprecatied. __________________ 2003 Sonic Blue Cobra

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Cobra-R Side Exhaust -- SWEEET!	SkammyManX	Modular Madness	3	04-05-2003 11:58 AM
exhaust cross-overs??	Simi Stang	Windsor Power	7	12-09-2002 01:20 PM
Speed Secret # 4	jim_howard_pdx	Windsor Power	13	11-10-2002 03:42 PM
Speed Secret # 3	jim_howard_pdx	Windsor Power	13	11-09-2002 10:35 AM
Header gaskets	Stang951	Windsor Power	18	11-01-2002 05:57 PM

03-28-2002, 11:48 PM	#2
sn95gt19 motors done......woohooo Join Date: Mar 2002 Posts: 799	you didnt say if they were equal length headers or just reg. i had a prob with the driver side header but if you just force it down past the master cylinder they fit fine it just takes some pushing. i had a bbk x pipe and the hangers that were for the trans crossmember didnt line up, so i didnt even use them it held up fine