© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-03-2001, 03:38 PM | #1 |
Registered Member
Join Date: Oct 2000
Location: Loveland, CO, USA
Posts: 30
|
Gear noise and pinion nut torque
Is it normal to have a little gear noise when increasing speed while using 3.73 Richmond gears. Also, does anyone know what the torque for the pinion nut is supposed to be. I had to replace the drive flang on the pinion and I'm not sure what to torque it at.
------------------ '93 GT Richmond 3.73 gears, BBK equal length ceramic coated shorties, BBK cat H-pipe, Flowmaster American Thunder cat back, 73mm mass air, BBK 190 lph fuel pump, Hurst shifter, K&N Filter Charger, Center Force Clutch, Aluminum drive shaft. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
need advice on axle noise | taurus3298 | Windsor Power | 1 | 10-09-2002 08:57 PM |
3.55:1 rear end noise, is it normal? | Mo65 | Classic Mustangs | 16 | 08-26-2002 08:07 AM |
Strang noise? Floor boards? | 93CobraR | Windsor Power | 1 | 01-20-2001 03:39 AM |