Sounds good, is it possible to use an impact gun with the air pressure turned down some to tighten the pinion/crush sleeve? I had a large breaker but it broke, plus I'm not sure I'm gonna have very much room being were working on jackstands. If it's possible to get the pinion on just right as long as I'm careful with the impact gun I'd prefer that, but I'm sure I can find a breaker bar/pipe if you think I really should. Also, any ideas on who makes the gears for Steeda? I'm probably gonna check the pinion depth being I'm not sure.
__________________
1990 Notchback: BBK Ceramic Coated Full length headers, Dr. Gas 3"- 2 1/2" x-pipe, Flowmaster 40's/turndowns.
|