Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-11-2003, 06:30 PM
|
#1 |
|
Registered Member
Join Date: Jan 2002
Location: PA
Posts: 79
|
prices for install
im most likely going to be getting some stock heads from a friend for free and porting them my selfand putting either 1.6 or 1.7 rockers on them. I figure since to put the heads on i need to take the intake off i might as well get a better on and put it on then too. So obviously im thinking of adding a cam at the same time. What would be a good intake and cam to match up with these heads and what should i expect to pay for install of this? thanks for the input
Ryan |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need good prices on engine rebuild kits | 82 GT | Windsor Power | 1 | 11-21-2002 02:03 AM |
| gas prices | mustang145 | Built Ford Tough | 5 | 04-02-2001 05:38 PM |
| gas prices | mustang145 | Blue Oval Lounge | 10 | 03-09-2001 04:20 PM |
| gas prices | mustang145 | Windsor Power | 4 | 03-09-2001 02:02 AM |
| gas prices | mustang145 | Small Ponies | 0 | 03-08-2001 11:32 PM |