MustangWorks.com - The Ford Mustang Power Source!

Go Back   MustangWorks.com : Ford Forums > Mustang & Ford Tech > Windsor Power
Register FAQ Members List Calendar Mark Forums Read

Notices


Reply
 
Thread Tools Rate Thread Display Modes
Old 02-17-2009, 12:56 PM   #1
meknized
fox fanatic
 
meknized's Avatar
 
Join Date: Jul 2004
Location: wichita Ks.
Posts: 61
Default H.O. cam

I just want to make sure on the cam, that you can use flat tappet lifters on an HO camshaft. The reason I'm asking is a guy I work with has a '85 Fairmont 302 with curiously, a 3 speed manual tranny. He's buying a set of rebuilt E6 heads and a carter carb. I have a a couple '90 Mustang cams and was sure you can run the cam with flat tappets but not the other way around. Am I right? I have never done that myself.

What happened to the forums on this site? I remember when the forums were blazing busy here.
__________________
meknized

Blue/silver 89 GT, Coast 331, ported GT-40x heads, X cam, cobra intake, 70mm TB, 75mm bullet, mac intake, 24lb inj, 255 lph fuel pump, accufab regulator, pulleys, MSD coil, 6AL, 300+ wires, Tremec 5 spd. pro 5.0 shifter, FMS drive shaft, headers, X-pipe, flowmasters, auburn pro series posi. moser 31s axles,3:73s, etc. Best ET 12.02@112.5
a pic A vid of a run:http://www.youtube.com/watch?v=l9JMcErxML8
meknized is offline   Reply With Quote
Reply


Thread Tools
Display Modes Rate This Thread
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 12:18 PM.


SEARCH