H.O. cam
I just want to make sure on the cam, that you can use flat tappet lifters on an HO camshaft. The reason I'm asking is a guy I work with has a '85 Fairmont 302 with curiously, a 3 speed manual tranny. He's buying a set of rebuilt E6 heads and a carter carb. I have a a couple '90 Mustang cams and was sure you can run the cam with flat tappets but not the other way around. Am I right? I have never done that myself.
What happened to the forums on this site? I remember when the forums were blazing busy here.
__________________
meknized
Blue/silver 89 GT, Coast 331, ported GT-40x heads, X cam, cobra intake, 70mm TB, 75mm bullet, mac intake, 24lb inj, 255 lph fuel pump, accufab regulator, pulleys, MSD coil, 6AL, 300+ wires, Tremec 5 spd. pro 5.0 shifter, FMS drive shaft, headers, X-pipe, flowmasters, auburn pro series posi. moser 31s axles,3:73s, etc. Best ET 12.02@112.5
a pic A vid of a run: http://www.youtube.com/watch?v=l9JMcErxML8
|