MustangWorks.com : Ford Forums

MustangWorks.com : Ford Forums (http://forums.mustangworks.com/index.php)
-   Windsor Power (http://forums.mustangworks.com/forumdisplay.php?f=8)
-   -   Had a close call today!!!!!!!!!!!!!!! (http://forums.mustangworks.com/showthread.php?t=5152)

blown5.0 08-13-2001 04:59 PM

Had a close call today!!!!!!!!!!!!!!!
 
I went to jiffy lube to get a tranny fluid change today. I have a 5speed. It turns out they were pulling out the wrong pin (reverse pivot pin) instead of the drain plug. The gears would not shift after that, but luckily they didnt pull it out all the way so they were able to put it back in. It seems to shift fine now. Should i be worried about anything or would my car have seen the worst while leaving the shop? I drove it hard just to make sure and it seems to be in order. Got lucky i guess. What do you guys think? Should be safe? Please say so!!!

------------------
1990 GT
Vortech S-trim 10-12psi 373s, fms upper and lower control arms
hurst shifter, mac offroad h pipe, warlock
catback exhaust,c&l 73mm mass air, 30lb injectors, mac unequal length headers,trex inline pump, msd btm

Stang Runner 08-13-2001 05:22 PM

Next time you might want to do it. I take my other car in to shop, But not my baby I do all the work on her myself http://www.mustangworks.com/msgboard/smile.gif

[This message has been edited by Stang Runner (edited 08-13-2001).]

BlackFly 08-13-2001 10:31 PM

yes, your horse should be fine. if it were to goof up it would have already, if something is out of place in your trans., you'll know right away, beleive it.


All times are GMT -5. The time now is 09:57 AM.