Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-18-2003, 01:25 PM
|
#1 |
|
Registered Member
Join Date: Feb 2003
Location: NJ
Posts: 81
|
Head Questions
Hi there i have a pair of gt 40p heads on my 86 gt i wanted to take the off to see how they are working my question is can i use the the same gasket thats on there, im not sure how long it has been on therer. thanks alot.
Ernie
__________________
93 GT 351 to 393 stroker, GT40 upper and lower intake, GT40X Turbo Swirl heads, holley 80mm throttle body, 255 fuel pump, 42 lb injector, JE pistons, Comp cam, comp lifters, comp pushrods, comp springs, crane Roller rockers. Trick flow Crank Shaft, comp Timing chain. MSD 7 series ignition, msd hvc2 coil, MSD timing adjust, MSD Pro billet Dis, Hooker long tube, Off road H pipe 1 chanber race flows, 4.10 gears, Vortech cooler and T-Trim with a 25lb boost AND LOTS MORE. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| block and head machining questions | bmxmon | Windsor Power | 6 | 09-26-2004 02:21 PM |
| After all normal bolt-ons... cylinder head questions | RED92LX50 | Windsor Power | 9 | 06-14-2003 08:43 AM |
| 351 head questions on my 5.0 | vetteeatr | Windsor Power | 0 | 08-28-2001 04:03 PM |
| Edelbrock Head Install Questions | Blaster | Windsor Power | 5 | 05-10-2001 12:22 PM |
| head gasket replacement stuff questions | fiveohpatrol | Windsor Power | 4 | 04-13-2001 04:23 PM |