Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-24-2002, 11:32 PM
|
#1 |
|
Registered Member
Join Date: Apr 2001
Location: Metairie, La. USA
Posts: 132
|
Header gaskets
Has anyone tried the copper header gaskets? I have to change mine already (only been a little over 2 years), and I dont want to keep this up every couple years.
__________________
Engine: 1990 5.8 / Edelbrock Performer set-up MSD ignition Suspension: Maximum Motorsports Caster-Camber Plates / Maximum Motorsports adjustable lower control arms / FRPP heavy duty upper control arms / Tokico Illumina Shocks and Struts / Ground Pounder Coil Over conversion kit front / Steeda cross brace sub-frame connectors / Drivetrain: Tremec 3550 trans / Steeda Tri-Ax shifter / Spec Stage II clutch and pressure plate / Spec aluminum flywheel / 5.8 in the hole |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Header and Exhaust Installation | 1991GT | Windsor Power | 4 | 12-03-2002 11:17 PM |
| header gaskets for 86-93 BBK equal length shorties? | stanger8172 | Windsor Power | 5 | 10-11-2001 09:55 AM |
| Gaskets - Which ones and where do I get them from? Please help quick. | 2FastLX | Windsor Power | 1 | 03-14-2001 12:08 PM |
| HEADER GASKETS | 91blownpony | Windsor Power | 5 | 01-26-2001 08:27 PM |
| Head Gaskets, Header Gaskets, Intake Gaskets, etc | AxemanZZ | Windsor Power | 8 | 01-11-2001 01:09 PM |