Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-27-2003, 10:26 AM
|
#1 |
|
Registered Member
Join Date: Jul 2000
Location: Norman, Oklahoma, USA
Posts: 597
|
GT40P header question
I'm going to use a set of GT40P heads. I know that the spark plugs are at a different angle than the stock E7 heads, but do you guys know of any long tubes that will fit these heads? I know you can get the FMS shorty GT40P headers, but what about long tubes? Thanks yall!
__________________
Michael Black QuantumMotorsports Norman, OK 1984 LX Hatch 306 w/ TRW forged flat toppers, Comp Cams Magnum 292H, GT40P heads w/ 3 angle valve job, .550 lift springs, Angus Racing Roller Rockers, Weiand Stealth Intake, Holley 4150 650cfm carb, MAC 1 5/8 Long Tubes, Single Chamber Flowmasters, 91' T5 w/ Pro 5.0 shifter, Turbo Coupe 8.8 Rear w/ 3.55 gears, QA1 Motorsports tubular K member, no interior except steering wheel and seat. Coming soon: 6 or 8 point cage, Fuel Cell, Weld Draglites |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Header Question | Jamie_DTR | Windsor Power | 6 | 04-17-2003 07:58 AM |
| Header question | bigred90gt | Windsor Power | 4 | 03-24-2003 12:38 AM |
| Header and Exhaust Installation | 1991GT | Windsor Power | 4 | 12-03-2002 11:17 PM |
| simple question | Lonzo | Classic Mustangs | 3 | 09-10-2002 09:37 AM |
| Header question | tomcat_37096 | Windsor Power | 3 | 10-08-2001 05:14 PM |