Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-01-2001, 06:39 PM
|
#1 |
|
Registered Member
Join Date: Apr 2001
Location: cohutta georgia
Posts: 43
|
edelbrock performer rpm heads
I need to know what head bolts,gaskets,and pushrods to use. I know that the pushrods will have to be hardened but can I use stock length?
------------------ 85 mustang coupe with a 88 block,83 model heads,crane roller rockers,aluminum driveshaft,C-4 trans,3500 stall,3.73 gears,lakewood traction action liftbars with air bag in right rear spring,longtube headers,flowmasters, weiand stealth intake,600 holley, best e.t. 1/8 mile 8.26 best mph. 81.35 best 60 foot 1.73 before liftbars on et streets. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Edelbrock RPM intake install problems | jruppert | Windsor Power | 4 | 03-04-2004 05:05 PM |
| Ford Performer RPM Heads | Scrapla | Windsor Power | 6 | 02-19-2004 09:53 AM |
| GT-40X Alumin. Heads/ Edlebrock Performer intake. Good combo? | yelowjaket | Windsor Power | 1 | 01-16-2003 03:16 PM |
| Edelbrock heads? | Coupe Devil | Windsor Power | 7 | 07-18-2001 03:58 PM |
| Edelbrock vs Trick Flow Heads???? | Blaster | Windsor Power | 8 | 04-25-2001 04:58 PM |