MustangWorks.com : Ford Forums

MustangWorks.com : Ford Forums (http://forums.mustangworks.com/index.php)
-   Windsor Power (http://forums.mustangworks.com/forumdisplay.php?f=8)
-   -   (HELP)everything in the car makes noise (http://forums.mustangworks.com/showthread.php?t=34662)

thiagoGT88 03-11-2003 09:10 PM

(HELP)everything in the car makes noise
 
Here's the deal, when I drive over a hole, or a bump in the street everything in the car makes noise, so i want to know if there is a place where they fix that... Any help would be appreciated.

Thanks;)

sn95gt19 03-11-2003 11:18 PM

tighten every screw in the interior, they have probably just worked themselves loose over the years.
get subframe connectors.....it should help a little bit

jimmyjamed 03-12-2003 12:04 AM

I put some electrical tape where 2 panels meet when I take interior stuff off. Not haveing as much plastic rubbing on plastic cut down alot on squeaks. But I second checking for loose screws.

88workcar 03-14-2003 07:23 AM

The next time you happen to pass through Pierre Part, La. look me up, one mile down our roads, in my car, and you will never complain again. :D

Simi Stang 03-17-2003 07:00 PM

rattles
 
Quote:

Originally posted by 88workcar
The next time you happen to pass through Pierre Part, La. look me up, one mile down our roads, in my car, and you will never complain again. :D
:p My car is quite the rattle trap too. My Eibach specific rate springs are killing me! Hopefully when I switch to progressive rates...it will help out some.

88workcar 03-17-2003 09:15 PM

Mine actually rides very well, it just rattles quite well also.

V8Mustang 03-17-2003 10:33 PM

Just don't tighten the screws too much or you will start breaking stuff. You could also stop by the dealer, probably any car dealer, and pick up a NHV (noise, harness, vibration) kit from the parts dept. It should consist of some felt pads with a sticky backside. You can place these between plastic parts on the dash to reduce the rattling.


All times are GMT -5. The time now is 02:23 PM.