© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-01-2001, 03:33 PM | #1 |
Undescribable
Join Date: Sep 1998
Location: Ft Myers Fla
Posts: 1,539
|
drilling firewall?
I am installing an oil pressure gauge and water temp gauge where can i drill to get them through to the engine compartment??
nothing on passenger side, only can see through on drivers side. I'm putting them in the center ac vents. ------------------ 93-LX: 5 Speed, Flow's with H-Pipe, 3.73's, C&L 76MM Kit, Sub's and K&N. 14.85 @95.83 |
08-01-2001, 05:02 PM | #2 |
Registered Member
Join Date: Feb 1999
Location: Smithton, IL, US
Posts: 215
|
If I remeber correctly I just used a long screw driver I pushed it through the gorment(sp?). I think it was the clutch cable or speedo. I have three wires running throught mine and no drilling works great.
------------------ Check my site for mod www.fordmustanggt.com |
08-01-2001, 06:12 PM | #3 |
Undescribable
Join Date: Sep 1998
Location: Ft Myers Fla
Posts: 1,539
|
I am using mechanical gauges, need a big hole for the temp gauge fitting.
------------------ 93-LX: 5 Speed, Flow's with H-Pipe, 3.73's, C&L 76MM Kit, Sub's and K&N. 14.85 @95.83 |
08-01-2001, 10:01 PM | #4 |
Registered Member
Join Date: Jan 2001
Location: ny
Posts: 197
|
pop the grommet out and carefully put a slice in it with a razor. then you can push the water fitting through.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Firewall Adjuster? | StateTroopCoupe | Windsor Power | 1 | 02-14-2004 08:52 PM |
Problem with Steeda firewall adj.? | RageGT | Windsor Power | 2 | 12-30-2003 08:19 AM |
Best way through firewall | XTheOwl | Modular Madness | 1 | 07-05-2003 08:19 AM |
Firewall Adjuster | 98SNAKE | Modular Madness | 0 | 10-03-2001 08:27 PM |
T-Trim, PCV Valve, Oil on firewall???? | Sparkplug | Windsor Power | 2 | 09-20-2001 04:01 AM |