Stock Windsor with heads/cam
 

! was wondering what kind
of power people are making with a good set of heads/cam on a ]
stock Windsor. I'm wanting to hit around 410rwhp with mine and run high 10's NA....anyone there??


Thanks
Scott

so what your saying is stock bottom end ?

not as much of a problem as choseing which heads cam intake etc you want to go with.

for a little more money you could have forged pistons better rods (truck rods are better than car forcheap people like me have them polished and shot peened ) and the cranck shaft bearings are a area that is money well spent.

But the real restriction is the stock heads cam and intake and you will be doing away with those.

:)

My bad, I was too vague. The W I have will have stg 3 TW heads
252/262, 600,618, 106 solid roller, Victor jr carbed intake, BG silver claw, Hooker full length headers, custom 3" X pipe exhaust.
I had the stock pistons flycut so this cam would work. It'll have around 9.5:1. full Wolfe suspension and a Tremec.

I'm going LS1 hunting:)

Anyone have something similar to this?

Scott

wow
 

you go hunting LS1's with that combo they will become extinct,real quick geez that is a lot of cam for a street car.

Good God!! 106 LSA on a street car? D*MN!

Looks like your pretty close, my dyno program says 433hp. Bump the compression up an extra 1/2 point and you will probably have the rear wheel numbers you are looking for. Of note, I think your cast pistons are a 'ticking bomb' with that much power.

http://www.members.aol.com/rhamm1320...no07140202.gif