Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-03-2002, 03:32 PM
|
#1 |
|
It's never clean enough!
Join Date: Jan 1999
Location: Shaler, PA
Posts: 1,542
|
Battery is dead after pulley install?!?
I finally got the chance to get my pulleys on the stang. I only changed the water pump pulley and the crank pulley. I DID NOT change the alternator pulley. Now, when I start the car, the battery gauge shows the volts in the red and shortly after, the battery dies. Even when I give it gas, it seems like the battery doesn't charge up. I just bought the battery last september so it should still be fine.
I was planning on buying a 140 amp alternator and then putting the aftermarket pulley on it. If I do this, will I still have charging problems??
__________________
~Dan 2001 SVT Lightning  89' GT : Taking up garage space and waiting for a buyer... Rice Hater's Club - Member #11 |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Help with blower pulley install | 7up | Windsor Power | 2 | 07-06-2002 11:45 AM |
| help, my battery keeeps going dead | mustangLX92 | Windsor Power | 13 | 09-10-2001 03:45 PM |
| Battery Disconnect Install Question? | Sparkplug | Windsor Power | 7 | 07-29-2001 12:29 AM |
| Pulley install is a ***$$$####@@! | bark3rd | Modular Madness | 6 | 05-25-2001 04:52 PM |
| Starter refused to dissengage, battery dead. | Radon | Windsor Power | 15 | 02-12-2001 03:52 AM |