© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-25-2001, 08:08 PM | #1 |
Guest
Posts: n/a
|
HELP PLEASE, CAR WONT START!!!!!
had to replace the head gasket and the front seal (new short block only 100+ miles)..
got it all back together and it won't fire!!! I have checked the timing mark on the crank and distributer alignment with the #1 plug.. checked the firing order about 10 times, 15426378, (cam sez to use this firing order),,,, checked the pos into the coil, it has power.. but if I pull a plug and ground it, I can't see any spark..... Any ideas?????????? I am so confused...... ------------------ Black,84 GT,ground effects,shorty headers, 'open' dual exh.,302 HO(no pollution control crap)bored .060, 10.5" clutch, T5,89 ported heads, edelbrock Performer manifold, Edelbrock 2122 cam, 600 Holley, high volume oil pump, front P235/60/R15's, rear P245/60/R15's..... Some day (3:73 gears & N2O)!!! will this ever end???? |
08-25-2001, 08:31 PM | #2 |
Registered Member
Join Date: Mar 1999
Posts: 88
|
Dude, if you have an H.O. use 1-3-7-2-6-5-4-8
How old is the coil, did you test it with an Ohm meter for resistance..? How old are the plug wires? You could have a cracked coil wire. Have you used a spark tester to see if you are even getting spark to distributor..? .dave |
08-25-2001, 10:21 PM | #3 |
Registered Member
Join Date: Nov 2000
Location: Milwaukee,Wisconsin
Posts: 380
|
JerryIII,
Sounds like a nice car, what does it run? My car wouldn't start the other day but that was due to a bad battery ground. The bolt to the bumper came loose. Good Luck getting in the 13's, don't stop till you get there! ------------------ '91 LX convertible , T-5, Centerforce Dual Friction, FMS adjustable cable w/quadrant, 3:55's(not installed yet), ported/polished/milled E7 heads, 1.6rr, 1.94/1.60 stainless valves, March Performance Pulleys and A/C Eliminator, short belt, Home Depot ram air, K&N, battery in trunk, glasspacks w/turndowns, 225/50/16 Re 730's |
08-26-2001, 02:54 PM | #4 |
Guest
Posts: n/a
|
Dude,
I've had starting problems before when I've pulled the ditributor. Check the following: No.1 piston at TDC of the compression stroke, timing marks at TDC on your balancer, distributor rotor aimed at the no.1 spark plug post of the cap. If you are sure you have done all of that and it still doesn't start, then the problem lies elswhere. Good luck! |
08-26-2001, 08:58 PM | #5 |
Guest
Posts: n/a
|
thx for all the responses, I checked the distributer this morning (after pulling the timing cover to verify), two of the wires had a crack in the insulation, theses two wires were grounding to each other, thus the no start.....
it's running now,, thx again.. ------------------ Black,84 GT,ground effects,shorty headers, 'open' dual exh.,302 HO(no pollution control crap)bored .060, 10.5" clutch, T5,89 ported heads, edelbrock Performer manifold, Edelbrock 2122 cam, 600 Holley, high volume oil pump, front P235/60/R15's, rear P245/60/R15's..... Some day (3:73 gears & N2O)!!! will this ever end???? |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wont Start, help! 1995 GT 5.0 | Year2001Boogie | Windsor Power | 13 | 05-05-2004 09:26 PM |
Wont Start, Dies, Help ! 1995 GT-5.0 | Year2001Boogie | Modular Madness | 8 | 04-29-2004 02:12 PM |
sometimes car turns over a lot but doesn't start | MineralGray02K | Modular Madness | 3 | 09-16-2002 10:41 PM |
car wont start!! | 50bird | Windsor Power | 1 | 08-09-2001 05:53 PM |
HELP- CAR WONT START | jimdrechsler | Windsor Power | 12 | 06-29-2001 08:44 PM |