© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-27-2002, 12:48 AM | #1 |
Registered Member
Join Date: Nov 2001
Location: santa rosa ca.
Posts: 121
|
holley ??????????
how do u adjust the air/ fuel mix on a 600cfm holley? thanx
__________________
65 fastback Keith Craft 408w 11:1cr AFR205's , Vic Jr. , 750 Speed Demon , MSD Digital 6+ , Aeromotive fuel system , Hooker Super Comp ,Headers , Art Carr roller C-4 w/ 10" converter and trans brake |
01-27-2002, 05:49 AM | #2 |
Junior Member
Join Date: Mar 1999
Location: Ventura, California
Posts: 8,981
|
1) Gently turn both mixture screws in until they bottom out.
2) Back them both out 1 1/2 turns. 3) Warm up engine 4) Turn idle speed down as LOW as the engine will maintain. 5) Adjust the screws in two round trips (adjust one side, then the other, then come back to the first side, then go back to the other side) to get the highest RPM. 6) Add an aditional 1/8 turn out for each screw. 7) Reset idle speed to desired level. 8) Shut off engine and check that both screws are the same. If they're not, set both to the average of the two. 9) Restart engine to check idle quality. Take care, -Chris
__________________
Webmaster: Rice Haters Club Jim Porter Racing Peckerwoods Pit Stop Support Your Local
RED & WHITE! |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Impressions of the Holley Intake. | Skyman | Windsor Power | 19 | 07-02-2002 10:05 AM |
Road Demon vs. Holley Avenger | Rev | Blue Oval Lounge | 5 | 09-12-2001 08:57 PM |
Well I did a compression test and it doesn't look goo for my Holley heads... | Rick 91GT | Windsor Power | 6 | 02-20-2001 07:43 AM |
Holley Heads??? | DemonGT | Windsor Power | 8 | 01-03-2001 09:05 AM |