MustangWorks.com : Ford Forums - View Single Post

79Stang · 01-20-2001, 05:10 PM

I was having some idle problems with my Holley 750 (vac. sec) so pretty much rebuilt the carb. I'm still having the same problem's though... I have a ruff idle and and I can tighten one of the mixture screws all the way down and the car will still run... The float level is fine, installed new needle/seats...

I am gonna hook up a Vacuum gage and see where that takes me, but any ideas?????

Thanks!

01-20-2001, 05:10 PM	#1
79Stang The Stang Gang Join Date: Jan 1999 Location: St. Petersburg Posts: 63	Holley Problems?! I was having some idle problems with my Holley 750 (vac. sec) so pretty much rebuilt the carb. I'm still having the same problem's though... I have a ruff idle and and I can tighten one of the mixture screws all the way down and the car will still run... The float level is fine, installed new needle/seats... I am gonna hook up a Vacuum gage and see where that takes me, but any ideas????? Thanks!