Re: Honing Mistake?
Main clearances are 0.0015", rods havent checked yet, still waiting on a rod from CHP. No signs of detontation. Completely disassembled block and have started over again. Been doing lots and lots and lots of cleaning. Crank and cam are installed. I just re-installed the cam, does the cam/timing chain wiggle at all(cam play)? spec is 0.005" NOT SURE HOW TO MEASURE THAT. the cam moves when the spocket and timing chain are not on, however when i reinstall the cloytes double roller timing chain, it seems like there is NO play.
__________________
1983 mustang, 393 cubic inch stroker small block, victor jr heads and intake, gold race 1.6 roller rockers. comp cam 304, 244@ .050. .576" hydralic retro roller cam,lunati rods. block was o-ringed,10:1 forged pistons, speed pro fit fit rings, clevite bearings,msd distributor and igniton,be cool huge radiator, black lite electric fan, march underdrive pulleys, mildon deep sump oil pan, mac 1 3.4" long tube headers, 3" dr gas x-pipe and mac exhaust,ARP bolts. car weighs 2900 lbs w/out driver, sub frames, weld wheels, mickey thompson sportsman pro 26 x 10.5 x 15's,#8 fuel line steel braided
|