horse power estimate??
 

i was just wondering if anyone could help me out wit a knowledgable estimate becuz i have herd a very wide range of numbers so im lookin to get a good anwer. i have a 89 lx hatch trick flow aluminum heads, trick flow stage 1 cam, holley long tube headers , mac exhuast/ no cats , 255 pump , 24 lbs, trick flow upper and lower intake, ford racing adjustable timing chain, ford racing pullies , 3.73's in the back , bbk cai, 70 mm tb, 73 mm maf. any replies would be greatly appreciated, i am fairly new to the site, my name is doug and i just turned 17 years old and will never drive anything but a mustang! im also wondering if a dyno tune is 100% neccasary because i am affriday of damaging the motor on the pull because every last dollar i have is in that car and have no money to replace anyhting right now.


-thanks guy

Re: horse power estimate??
 

i would say some where in the 325 hp range .....you wont blow up your engine on a dyno with your mods...dyno tuning with your mods will add lil bit more power more its more to make sure your engine has very good air fuel ratio so ur not running lean or rich and adj the timming and so on...

Re: horse power estimate??
 

320 to 350 at the flywheel. With the mods you have a dyno tune would make your stang more powerfull and streetable but it isnt necessary.

The car should make around 300 to the wheels and run 12's with ease. Be carefull with all that power at such a young age.;)

Re: horse power estimate??
 

thanks alot for the responses guys, well i wont have to worry bout driving it for a while becuz i live in new york and theres snow on the ground already so im not going anywhere. Becuz its going to be off the road anyway i plan on puttin a vortech in it but only puttin out bout 6 or 7 lbs, is a dyno tune a must after the sc? i have to sell a 92 gt to get the money for it, i know its the wrong forum but if anyone interested in it let me know...new motor with 13k miles on it body is shot ....great winter project.

Re: horse power estimate??
 

i would deff get a dymo tune with a sc..i wouldnt think twice

Re: horse power estimate??
 

Why are you so afraid of the dyno? If you put on a new S/C, of course you are gonna need to dyno it. Also, you may want find out exactly just what's inside of that block of yours. I hope it's not running flat top pistons. Sounds like whoever built that motor was going N/A not S/C.