is this a hot engine combo? take a look!
 

whatcha think of this complete combo:

Edelbrock 6037 pedastal mount heads
Anderson N-41 cam
Crane 1.6 rr's
Edelbrock RPM intake
BBK 70mm TB and EGR
Pro-M 75mm
FRPP 30# inj.
Mac cold air intake

then ima get new lifters, possibly high flow water pump, new double roller timing chain. and what else?

tell me what u think?

thanks for your time and help,

Luke

Should run VERY strong...that N-41 is a good cam. You will love the BBK 70mm...especially the tubine-like whistle....sounds like you are gonna blast off.

I would say that wit the right tuning, you could make 285-295 rwhp.

I had a similar setup on my "pre-blown" motor that had TFS TW's, TFS #2 cam, TFS Track Heat, 70mm, 77mmMAF, and rockers, exhaust...303 rwhp. The only difference basically was the heads...the TW's are a litle better flowing.

one thing... if you dont have the rockers or the heads... go with stud mount instead.. :cool: