© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
11-21-2005, 11:18 PM | #1 |
Registered Member
Join Date: Feb 2003
Location: Washington
Posts: 33
|
How long does it take moly rings to seat?
I have about 350 miles on this re-ringed engine and I brought it up to 5000rpm and popped the dip stick out again. This happened on the last ring job too. I had 13-16% leak down across all cylinders last time and they only had 1500 miles so I had the engine honed and ringed again with standard moly rings on probe forged flat tops. Are the rings just not seated yet? Compression is 10:1 if that matters at all. All other engine mods are in sig. Thanks for any help.
__________________
New 302 block, Probe forged pistons,Moly rings,I-beam rods,Main girdle,Canton 7Qt pan,B-cam, Edelbrock 6037's ported/decked,Exploder upper/lower ported,#24 inj,190lph fuel pump,70mm tb,73mm maf,MSD dist/coil,6al box,3.73's,Steeda lca's,QA1 k-member,subs,strut tower brace. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Seatbelt Laws... | StangFlyer | Blue Oval Lounge | 45 | 04-25-2021 04:06 PM |
BBK long tubes on P heads | procharge94 | Windsor Power | 0 | 05-04-2005 03:05 AM |
TFS High Ports and Long Tubes | HORSEMEN RACING | Windsor Power | 3 | 07-16-2002 12:57 PM |
1991 Back Seat Bracket??? | jz_mustang50 | Windsor Power | 0 | 10-07-2001 08:39 PM |
BBK one-piece flange or MAC individual flange long tube headers. | Fox Body | Windsor Power | 10 | 04-03-2001 04:25 PM |