

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
![]() |
#1 |
Sniffed too much n20
Join Date: Oct 1998
Location: Ont, Canada
Posts: 1,018
|
![]() I've got my engine on a stand, and I'm not taking it apart. I don't have money for new bearings, etc. How do I notch my pistons to make my valves clear. (TFS Stage 2 cam, 1.90/1.60 valves with 1.6RRs). I've heard of using a Dremel, but what bit? I've also heard of using a grinder with a small grinding wheel, but I can't find anything smaller 3 1/2". Any other suggestions? I don't have access to an old set of heads, so getting the tool that sits in it is out of the question.
|
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Notch goes 3 and 0 | tireburner163 | Stang Stories | 7 | 04-28-2004 09:14 PM |
Largest cam in 351W without cutting the pistons (Looking at AFR185s) | Fox Body | Windsor Power | 10 | 06-15-2003 12:39 AM |
Pistons for Larger Valves? | MustangChile | Classic Mustangs | 4 | 02-28-2003 01:27 AM |
Rear Speaker options for 90 LX Notch??? | Chevyguy | Audio, Security, & Electronics | 3 | 11-01-2001 07:50 PM |
Notch wasn't so mighty! | Try Me | Stang Stories | 5 | 03-26-2001 04:08 PM |