where are those located? Can they be tested, or do they have to be replaced?
This is the whole situation. My engine was rebuilt about 1 year ago. I put the engine back in and screwed something up while trying to get the distributer in right. I got the engine started but wasn't getting power until 3000 rpm's. Instead of pulling the dist. out and moving it in one tooth over, I tried to pull the plug wires off the dist. and move them one post to the right. When I tried to start the car, nothing. I moved the plug wires back where they were when it started, and nothing. Now, when I try to turn the engine over, the fuel pump primes and the accessories come on, but the starter doesn't crank the flywheel. I tested the new coil I installed a few weeks ago, and the multi-meter shows that it's holding the right amount of power. When I test for spark (pulling the plug out and setting it against metal), I don't get spark. I tried starting it by putting a screwdriver against the ignition post and the power post on the starter relay and the starter cranked the flywheel over. I'm not sure what to do. or what to replace, but thanks for any help or ideas, Keith
|