Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-21-2003, 06:47 PM
|
#1 |
|
Registered Member
Join Date: Sep 2002
Location: IL
Posts: 105
|
i need to know!
ok i put the new module in my new distributor and the car started up great, then i timed it and it sounds good. now i am going to start trying to drive this car around and i need a checklist for my car so i can make sure it is good to go. EVERYTHING on the inside is new, including the springs, distributor, wires, rotor and cap... Water pump, oil pump and shaft, injectors and throttle body along with the EGR backplate, and all sensors. Many things are new i think the only stock think that is left is the upper and lower intake that is polished and ported and the ignition coil..... any avdive on how long to drive it for and what to do to break it in?? THANKS!
__________________
89' GT with 5spd Hurst short throw, Keith Black 12:1 comp. pistons, Sealed Power drag racing rings, Fms F303 Cam, Ported and polished upper and lower intake with Ported E7TE heads that contain comp. cam double coiled springs with titainum locks and steel retainers, Fel-Pro Head Gaskets, 9mm ford racing wires, BBK chrome unequal shortys, Power Throttle bodies 70mm, Edlebrock 70mm EGR plate, 15inch K&N, Bassani X-pipe, Flowmaster 40 series, Eibach 1 1/2 lowering springs, Cobra R rims 17X9 with p235 on front and p275 on rear with Falken Zeix tires-RUNNING! |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|