Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-02-2004, 08:11 AM
|
#1 |
|
Mizzou Tigers
Join Date: Apr 1999
Location: weston, MO United States
Posts: 1,455
|
High idle
My Stang is still idling high. I have set the TPS, replaced the IAB, and replaced the computer. I can't find any vacuum leaks and don't see anywhere where the cable might be getting stuck.
It is an intermittent problem and when it happens my idle sticks around 2000 rpm. Even when it is not sticking, I can't get the car to idle below about 1200, even though I have the idle screw backed competely out. What else can I look at? Could my TPS be bad? What resistance should it show? This is really starting to get frustrating 
__________________
2006 Mustang GT 1990 LX GT-40 motor 262 horsepower, 307ft-lbs (sold but forever loved) 1998 Contour SVT Rice Haters Club Member #244 |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Adjusting Length of high idle on Carb 5.0 | twilightcall | Windsor Power | 8 | 08-06-2003 08:31 AM |
| Low, loppy idle then too high, then low again.... | Fox Body | Windsor Power | 6 | 08-05-2003 11:29 PM |
| Idle too high, Popping thru intake still . . . | SheStang87 | Windsor Power | 3 | 06-23-2003 10:32 PM |
| Still Am a high Idle...... | Stang Runner | Windsor Power | 3 | 05-06-2002 04:23 PM |
| Idle too high after TB install... | Bad89stang | Windsor Power | 18 | 04-24-2002 09:41 PM |