MustangWorks.com : Ford Forums - View Single Post

1995gtStang · 07-18-2003, 07:52 PM

I own a 95 GT Mustang 5.0L and I'm having Idling problems... I read on an earlier post that a lot of times it's the IAC Valve Gasket, I confirmed this with my Local Ford Dealership and purchased and install a new one. I had to take the distributor off to get to the IAC Valve to install the new gasket. The old gasket was worn a bit but seemed like it would do the job fine.

Everyonce in awhile when I come to a complete stop and start to apply the gas the car will either stall or drop to about 600rpms then it's fine after I get up to about 25 mph.

When I took off the distributor cap the rotor was a little corroded on the contact would that be a possible problem with the idling? The spark plugs are fine and like I said I just installed a new IAC Valve Gasket so that's not it.

What else should I do to try to remedy this problem?

07-18-2003, 07:52 PM	#1
1995gtStang Registered Member Join Date: Jul 2003 Location: Nebraska Posts: 6	Idling Problems I own a 95 GT Mustang 5.0L and I'm having Idling problems... I read on an earlier post that a lot of times it's the IAC Valve Gasket, I confirmed this with my Local Ford Dealership and purchased and install a new one. I had to take the distributor off to get to the IAC Valve to install the new gasket. The old gasket was worn a bit but seemed like it would do the job fine. Everyonce in awhile when I come to a complete stop and start to apply the gas the car will either stall or drop to about 600rpms then it's fine after I get up to about 25 mph. When I took off the distributor cap the rotor was a little corroded on the contact would that be a possible problem with the idling? The spark plugs are fine and like I said I just installed a new IAC Valve Gasket so that's not it. What else should I do to try to remedy this problem?