© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-25-2001, 11:39 AM | #1 |
Registered Member
Join Date: Nov 2000
Location: Zeeland,Mi,USA
Posts: 16
|
more shortblock questions
Well after weeks of narrowing down between 347 vs 331 and picking a builder, and getting close to ordering a Kieth Craft 331, i've decided to do a little more investigation as to what would be the best route to go.
So this weekend I'm going to take a junk 351w block bolt on my heads and headers and see if it will fit where it needs to in my truck. So here is my questions: Does anyone know about 351 strokers? Kieth Craft offers a 357, 393, and 408 which are all the same price. Jason suggested the 408, but i was wondering about rod ratio and life. Should I just go with the 393? Any info you have would be greatlly appreciated. ------------------ Prerunner F150 with 92' Mustang 302, Aftercooled Vortech S-Trim with 2.75 10 rib pulley set, Maxflow bypass, Vortech Fuel Rails, Cartech inline Pump with #8in and #6out feeding 36lb injectors, Powerflex 4" inlet tube Edelbrock Aluminum Heads(2.02/1.60), HIFLO waterpump, 70mmTB, Performer intake, MSD 6ALBTM, Doug Thorley Tri-Y Long tubes to single DynoMax Race Magnum, C6 with 2600 Stall 4.10s with Lockers, engine relocated 14.5" rearward!! |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
speedy density to mass air questions | thdrcat | Windsor Power | 3 | 09-25-2003 09:20 PM |
New Gears, Install, and Questions | B2r3y | Windsor Power | 6 | 02-21-2003 05:00 PM |
Need advice on Shortblock... | MustangDanny | Windsor Power | 8 | 01-14-2002 05:29 PM |
S/R Questions | DAMION | Racer's Club House | 1 | 09-30-1999 11:02 AM |