I've got a MSD Blaster 3 coil.
primary terminals showed a .3, but it would show it for a split second and go down to .1 and finally to no reading. Is that suppose to happen? I would leave the negative probe on pull off the positive and put the positive back on and it would do the same everytime... .3,.1, and nothing.
Primary neg. terminal to secondary terminal showed 4.85
These readings are with all wires pulled from the coil.
Time for a new coil?
Is there any way to check the MSD ignition box to see if it's running up to par also?
__________________
91 LX - 10.5:1 pistons, ported 289 heads, Ultradyne 588 cam, Cobra upper/lower, MSD, JBA long tube headers, Flowmaster, Richmond 4:10, roll cage, monster tach...FUN!!
95 SHO - K&N filter
|