[ricechefmerkl]

lol exactly what i was going to do , i have a set ( well three) that i spent 8 hours glass beadin at school when i was planning a cheap streeter motor , which i will probally do with my 79 block after the right bits show up for our boreing bar so i can put a sleeve in it at i put my 69 block .030 over , i had never seen a piston let go like the one in the 79 block though it just ripped apart right at the pin bosses and wedged the piston in a angle in the cylinder , and well round things only fit good in a round hole when they are flat i guess when you try to turn then side ways in there they do some damage who would have figured hey lol