Which Injectors
 

I would like to know if 24LB injectors woulb be to big for the combination below or should I keep the 19Lb injectors. This car is a drag race car only with no power adders. Thanks



30 over block, Edelbrock 6037 Heads, Trick Flow Stage 2 Camshaft, Edelbrock Performer RPM Efi Intake, H-pipe, 1 Chamber Flowmasters,75 Bullet Mass Air Meter, 70TB, Mac Cold Air Induction, Mac full length Headers, Bradco C-4 Transmission, Bradco 3500 stall converter, 4.30 gears, Strange C-Clip Eliminators with 33 Spline Axles, Timing Set At 16, TPS Set at .96, 190 Walbro Fuel Pump, Fuel Pressure set at 39, MSD 6AL, Transbrake, 15x3.5 Weld Wheel On Front, 15x10 Welds On Rear with 28x9x15 Hoosier Drag Tires.

24's will work great, just make sure your mass air meter is calibrated for them

heck, you could also go with 30's and turn the pressure down. This will leave you room to grow in the future if you plan on anything more.

19s will work well also.

24 lbs/hr injectors are the best choice for your car. The 19's will work, as long as the fuel pressure is set correctly.

What should the fuel pressure be set at. Thanks

i would use 24's at 40lbs pressure

I made 300 to the wheels with the 19#'s set to 50-54 PSI(Depending on weather).