Installed my cam today
 

Well, after 2 days, I got the b-cam in and got the car running. Sounds great and pulls harder than before. The only problem is, now my computer is throwing a code 31. Nothing seems to be affected by the problem, as far as I can tell. If anyone has any insight to the problem, feel free to fill me in. Thanks folks.

Caymon

The guys at Autozone can tell you what the code means. As far as I'm concerned though, I used to want to have no codes at all pop up, but now I'm to the point where if the damn thing runs hard, who cares!! Sounds like you did a good job with your cam install. Go drive it like you stole it!

EVP - EVP signal is/was out of range - EVP
according to http://www.troublecodes.net/Ford/

later bro they have all the codes

Thanks for the link. I posted the code on RHC and as soon as someone said egr, I remembered that I didnt plug in the connector on the back of the egr valve. Stupid me. I was in too big a hurry to hear the car run.

I have that code on my car.. though my egr is plugged in correctly.. what could cause this.. could it be a problem with the valve mecahnism?
-as